Aqualisa Digital Processor

If you are handy using a philips screwdriver you can remove the cover. (don't forget to turn the water off on the inlet pipes) Open the mixed unit by removing the two philips screws that hold the collar in place.

Inside there is a metal disk (this is the mixer) underneath are two washer that fit over two springs when these stick the water continues to flow.

Remove them by pushing them into the socket they should then pop out. Once out apply silicone grease reinsert and put everything back together

The leak is caused by the rubber seals inside the mixer unit in the processor.

If you are handy using a philips screwdriver you can remove the cover. (don't forget to turn the water off on the inlet pipes) Open the mixed unit by removing the two philip screws that hold the collar in place.

Inside there is a metal disk (this is the mixer) underneath are two washer that fit over two springs when these stick the water continues to flow.

Remove them by pushing them into the socket they should then pop out. Once out apply silicone grease reinsert and put everything back together

Yes it is possible.... but an electrician should have beenable to tell if this was causing the problem or not.

The processer is regarded as a sealed unit so you have to buy the complete processor..

However it has a 5year guarantee, so check when it was installed