Mira Enduro 1.5 Bar Shower Pump

A: 

I am not sure I follow The PPT3 Should have had a live, neuraland earth and these three wires should go to the LNE on the new pump.

 

Pages 16 and 17

http://www.mirashowers.co.uk/onlinecatalog/pdf/1074846_w2_a.pdf

 

The S! And S” connections are for the flow switches and youshould have no need to touch them.

 

If this doesn’t solve the problem can you send me a photo

A: First you will need to test if you have a leak in your system. If not you could have a faulty reed switch which is marked as part 7 on the diagram.

 http://www.showerdoc.com/shower-spares/mira/MIRA-PARENT-97-Mira-Enduro
You will need a multi meter to do this.

If these are found to be ok then I would suspect a pcb fault.

A: 

Sorry for the delay in replying

 

These are the available parts for the Supa jet

http://www.showerdoc.com/shower-spares/supajet/SUPJ-PARENT-2-Supajet-101

Please see note a foot of page.

A: 

The connections the Enduro comes  with 4 x 300mm braided flexible connectors each featuring push-fit connector so depending on how your existing pump is fitted you will probably need to cut a little of the pipe work to allow the pushfit flex connectors to fit

A: 

Yesit will be a twin pump, however you are not allowed to connect a pump to thewater mains and if the showers have been connected properly then they should beconnected to the mains.