I have got a Triton 300 si - indicator of low pressure flushing
It happened before but then things got back to normal.
A few months ago a water softer system was installed which reduced the overall water flow marginally. Do you think that could be the cause?
Would be grateful if you could provide some advice. Thank you!
The things to check first are:
1 That the main valve coming into your house is fully open.
2 Then check that the valve on the line to the shower is fully open.
If these valves are not fully open then there may not be enough water getting to your shower to cool it properly the overheat safety device will turn the power off until it cools Then it all starts again
Make sure that the shower head is clean and clear, that the hose isn’t kinked (this can happen just behind the hand set where it is difficult to see) also check the inside of the hose although it can look OK on the outside it could have collapsed internally
The other possibility is a faulty flow/stabilizer valve not allowing the correct amount of water into the shower.
Also if the water softener is restricting the flow/ pressure then yes this could be causing the problem.
Answered 9 years ago by Anonymous
View Spares and Order Parts:
Triton T300si Remote Shower Spares
Do you need any additional help to find the correct spare part?
Please click the following link if you would like to see other answers or ask a question regarding the Triton T300si Remote - Shower Spares
If you've landed here and this question is not about your specific product, please take a look at these similar items on our Triton Electric Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.
If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Triton Electric Showers
For any other support request please get in touch.