This question is regarding Aqualisa Aquastream - Thermostatic & Manual (post 1997) - Shower Spares

Pressure cuts and restarts (2)

Hi, I have tried asking a further question, which the link seems to

accept but then I don't see a reply at all. So can I try via here

please.



I've tried what was in the reply below but the problem persists. So,

to recap, the pump runs and we have full flow and pressure. After 2-3

mins the pump seems to cut out and the pressure drops. Another 1-2

mins later the flow kicks back in and the pressure is back again. This

cycle repeats. It feels as though something is causing pump to stop,

not sure if that means faulty pump or if it's more likely to be some

form of override or control cutting the pump off. In my mind the pump

would either work or not rather than in this intermittent way.



Any suggestions?
Asked 11 years ago by Eddie

I presume that you have checked that the water supply etc. IsOK

 

If the supply is Ok then you may have a problem with thetransformer

 

You will need a multimeter, check the voltage going to theshower from your transformer you may find that the voltage is going up and downwith the shower going on and off, if this is the case you are going to need anew train.

Answered 11 years ago by The Shower Doctor

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Aqualisa Aquastream - Thermostatic & Manual (post 1997) - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Aqualisa Power Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Aqualisa Power Showers

For any other support request please get in touch.