This question is regarding Aqualisa Aquavalve Outlet Assembly Kit (White) - 073220

fitting order

could you tell me the correct order for fitting
Asked 7 years ago by Vic
The Blank end is simple you just slip the black sealing ring over the plug slip it into the valve housing and screw the nut down hand tight.

The outlet end.

The threaded end sticks out from the valve and counting from the valve back out first the rubber sealing ring then the thin guide ring then the grab ring.

I would slip the guide ring on first followed by the sealing ring both from the plane end of the outlet connector and on about 1/2" an inch Then slip the grab ring on (It will only go one way) from the threaded end, slip it on so it clears the threads by a few mm then offer the complete assembly up to the valve this will push the sealing ring and guide ring up and into place, then offer up the nut as you tighten it ti will pull the grab ring up toward the the valve and the other rings, once again only hand tight.

Answered 7 years ago by George Thomson

View Product and Order Online:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Aqualisa Aquavalve Outlet Assembly Kit (White) - 073220

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Aqualisa Other Spares Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Aqualisa Other Spares

For any other support request please get in touch.