Fitting cartridge SK 1850-2

I notice your photo shows 'O' rings and circlip. Does this imply that the cartridge comes in separate bits which I will have to put together ? or can I put the large hex nut over the cartridge body and screw it together with spring & white splines into the receiving pipe in the wall ? Thanks C. Barry
Asked 7 years ago by Cornelius
The cartridge comes with the nut attached.

The spring , shuttle and thermostat will have to be added before fitting in the shower body.

There is a video on the link to help you.

Answered 7 years ago by Barrie Seabright

Thank you,

After I fit the spring, shuttle, thermostat, and cartridge etc. do I need to have the wheel that adjusts the water temperature in the hot or cold position before I operate the shower, or does it not matter ?

Thanks again,

C. Barry

Answered 7 years ago by Cornelius Barry

It should be OK when you refit it, however you may have to reset the temperature.

Video below.

www.youtube.com/watch?v=bQnHGckfW-g

Answered 7 years ago by George Thomson

View Product and Order Online:

Do you require any further help with Tap or Shower Cartridges?

Please click the following link if you would like to see other answers or ask a question regarding the Sirrus 1850/968 Thermostatic Cartridge without Thermostat - SK1850-2

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Bristan Cartridges page. Alternatively, if you're looking for any other brands you should view our full range of Cartridges.

If you would like to buy this cartridge or look others from the same brand, please view our Replacement Bristan Cartridges (All)

For any other support request please get in touch.