Water to hot

Can't get water to run cold think the dials may be set up wrong
Asked 8 years ago by Anonymous

It is possible that the dial could be set in the wrong place.

However…..

The things to check first are:

1 That the main valve coming into your house is fully open. 

2 Then check that the valve on the line to the shower is fully open. 

If these valves are not fully open then there may not be enough water getting to your shower to cool it properly the overheat safety device will turn the power off until it cools Then it all starts again

 

Make sure that the shower head is clean and clear, that the hose isn’t kinked (this can happen just behind the hand set where it is difficult to see) also check the inside of the hose although it can look OK on the outside it could have collapsed internally 

The other possibility is a faulty flow/stabilizer valve not allowing the correct amount of water into the shower. 


Answered 8 years ago by Anonymous

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Creda AquaWave Electric Shower (2006 - Current) - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Creda Electric Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Creda Electric Showers

For any other support request please get in touch.