This question is regarding Mira Advance ATL - post 2003 - Shower Spares

Mira Adavnce water does not stop even after putting supply off

Shower started on its own. I put off the power supply and had to close inlet cock. Water is not getting hot also. Shower was installed about 3 years ago but sparingly used.
Asked 7 years ago by Dayanand
It could be a faulty relay board or faulty flow valve there is no way to know for sure.However our experience is, if the service light comes on then it’s most likely to be a faulty relay board.No lights at all then it’s probably the relay board. If it’s low pressure light is on then it could be a faulty the flow valve or relay board.If you are unsure start with the relay board, this is the more common fault. On a few occasions you may need both, if you need to be certain then order both!

Answered 7 years ago by Barrie Seabright

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Mira Advance ATL - post 2003 - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Mira Electric Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Mira Electric Showers

For any other support request please get in touch.