This question is regarding Mira Advance ATL - post 2003 - Shower Spares

SHOWER going cold and switching off

I had a problem with my shower, it would run for about 30 seconds fine and then come on full force on cold then switch off - the low pressure lights was on. We replaced the flow valve assembly and everything ran smoothly for a week. It has now started to make a 'click' and the water then goes cold but it does not switch off, if we switch it off and switch it on again it goes back to the first problem running for 30 seconds low pressure lights and full force of cold water then switches off.
Asked 11 years ago by Anonymous

The things to check first are.

1 That the main valve coming into your house is fully open.

2 Then check that the valve on the line to the shower is fully open.

If these valves are not fully open then there may not be enough water
getting to your shower to  open / close the safety device that allowspower through to the elements.

If this is OK then it is most likelythat you have a faulty relay on the relay board which will mean that the boardwill need replaced.

http://www.showerdoc.com/mira-relay-board-and-earth-wire-406-88

 

Answered 11 years ago by The Shower Doctor

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Mira Advance ATL - post 2003 - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Mira Electric Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Mira Electric Showers

For any other support request please get in touch.