This question is regarding Mira Advance - post 2007 - Shower Spares

No Power going through

Last week i found a fault in the shower unit - reset light was flashing, so i pressed the reset button and it worked ok for about a week!

Now there is now power at all...



Asked 11 years ago by Anonymous
The first thing to do is check if there is power at the terminal inside the shower, you will need a multi meter for this. If there is then you have a faulty rely board. If not, check your ceiling / wall switch to the shower. Either way after the repair you will have to re commission the shower.
 You do this by turning the temperature dial to ( usually ) position 8 , then turning on the power to the shower, and before 30 sec have gone by, hold in both the HIGH/ LOW and the ON/OFF buttons. You should hear a beep, at which point you let go of the ON/OFF button, there then should be another beep
(sometimes not )  at which time you let go of the HIGH / LOW button. Commissioning is now complete.

Answered 11 years ago by Anonymous

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Mira Advance - post 2007 - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Mira Electric Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Mira Electric Showers

For any other support request please get in touch.