This question is regarding Mira Escape - Shower Spares

shower fault

my sis in law has one of these showers and it has started to go cold after about a minute then goes hot again. the pressure drops slightly when it goes cold then comes back on as if you have just started it up again???

any ideas which part is at fault cheers
Asked 13 years ago by Anonymous

The things to check first are.

1 That the main valve coming into your house is fully open.

2 Then check that the valve on the line to the shower is fully open.

3There is a filter on the inlet make sure that is clean and clear.

If these valves are not fully open then there may not be enough water
getting to your shower to cool it properly the overheat safety device will turn
the power off until it cools Then it all starts again

Make sure that the shower head is clean and clear, that the hose isn’t kinked (this can happen just behind the hand set where it is difficult to see) also check the inside of the hose although it can look OK on the outside it could have collapsed internally

If all of these things are OK then I think you are going to need a new flow valve.

http://www.showerdoc.com/shower-spares/mira/MIRA-1563-540-Mira-Flow-Valve---Inlet-Assembly-1563-540

Answered 13 years ago by The Shower Doctor

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Mira Escape - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Mira Electric Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Mira Electric Showers

For any other support request please get in touch.