Mira Extra EV Bath Shower Mixer with Shower Kit (White/Chrome) - 1.0.122.25.2

Bath-mounted ¾” bath and thermostatic shower control connection to two ¾” tail pipes. Supplied complete with a Mira Response Adjustable Spray shower head with three different spray actions (Start, Soothe and Force), hose, clamp bracket, soap dish, slide bar and hose retaining ring/gel hook.

Technical Specification
Limitations of Use
The Mira Extra BSM should not be used for applications where an outlet flow control forms part of the shower fitting.
The product and its components are only suitable for normal water supplies and should be cleaned only with mild washing up detergent or soap solution

Temperature
Wax capsule temperature control system.
Automatic shutdown to seepage if cold supplies fails.
Adjustable maximum temperature limit.
Temperature control range: 35°C – 45°C.
Maximum hot water temperature: 82°C (BS6700 recommends maximum of 65°C)
Minimum temperature differential: 12°C (between blend and hot).

Temperature (bath fill only)
Full hot to full cold can be selected by the separate hot and cold taps.

Pressure (inlet supplies)
Minimum maintained pressures: 0.1 bar (gravity fed), 1.0 bar (gas water heater)
Maximum maintained pressure: 5.0 bar
Maximum static pressure: 10.0 bar
Maximum pressure loss ration: 5:1

Performance
The bath taps will provide water at the hot and cold supply temperature from the bath fill outlet.
The single central knob allows the shower temperatures selected to range from the cold water supply to temperature through to the pre-set maximum.
The maximum blend temperature for the shower is factory set at 42°C. This can be re-set according to the site requirements.
Accurate maximum blend temperature can be set using typical inlet temperature: cold 10°C – 15°C, hot 60°C – 65°C.

Guarantee
Guaranteed for one year from date of purchase against faulty materials or workmanship.

Application
The Mira Extra BSM is designed for installations as part of the following plumbing systems:
Gravity fed
Fully instantaneous gas heated
Mains pressurised (heated from a thermal store)
Unvented mains pressure
Pumped
When the Extra BSM is used at pressures above 5.0 bar maintained, a drop-tight pressure reducing valve must be installed to maintain performance. Refer to the plumbing schematic diagrams for its position.

Installation
The plumbing installation must comply with the requirements of UK Water Regulations/Bylaws (Scotland), Building Regulations or any particular regulations and practices specified by the local water company or water undertakers. The installations should be carried out by a plumber or contractor who is registered or is a member of an association.
Protect the product from damage whilst making soldered connections. Some fluxes cause damage to plastic components.
Surface deck-mounted.
Inlet connections: 2 x ¾” BSP male tail pipes, suitable for all baths with tap holes conforming to British Standards.
Shower outlet connection: ½” BSP male.