Mira Orbis 9.8KW

Hello, I currently have a Mira Orbis 9.8Kw shower. Which was working fine. It started with an intermittent fault, where the 'low pressure' warning would come up as well as the LCD display flashing on and off (Blue backlight). The water however still flowing fully, just cold. But if you turned the temperature down to the lowest setting and pressed setting 1, it would come back on (temp dial working) and you could then put it on setting 3 and to the required temperature 37-38 deg-ish. Now however, the water still flows well, but I still get the 'low pressure' warning and the blue backlight flashing, but the water does not heat up at all, and the previous work around does nothing. Reading in the manual about this fault, I have cleaned the filter and flushed the supply pipe, but still nothing. I have checked across the solenoid and it reads 3.5Kohms. Any ideas on what the problem could be? Many thanks in advance,
Asked 5 years ago by John
It is likely to be the pcb on the front cover that is faulty or the relay board.

The only way to check is to replace them.

Answered 5 years ago by Barrie Seabright

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Mira Orbis - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Mira Electric Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Mira Electric Showers

For any other support request please get in touch.