mira elite2

low flow light is on water not heating
Asked 6 years ago by Ian
The things to check first are:

1 That the main valve coming into your house is fully open.

2 Then check that the valve on the line to the shower is fully open. And the inlet filter in the shower is clear.

If these valves are not fully open then there may not be enough water getting to your shower to cool it properly, it overheats the safety device cuts in (TCO) and turns the power off to the elements until it cools down and it all starts again!


Make sure that the shower head is clean and clear, that the hose isn’t kinked (this can happen just behind the hand set where it is difficult to see) also check the inside of the hose although it can look OK on the outside it could have collapsed internally


The other possibility is a faulty flow/stabilizer valve not allowing the correct amount of water into the shower.

Also check that the solenoid is working correctly.

www.youtube.com/watch?v=NzJjzWqxesc



There is a link below that explains the above.

www.youtube.com/watch?v=m0xrObqfGqg

Answered 6 years ago by Barrie Seabright

View Product and Order Online:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Mira Azora/Sprint/Sport/Zest Thermal Cut-out (TCO) - 416.41

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Mira Thermal Cut Outs Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Mira Thermal Cut Outs

For any other support request please get in touch.