This question is regarding NewTeam 201 Thermostatic / Manual - Shower Spares

Heat loss

I turn the shower on and set it to cold the pump starts,turn the control to mix ,no change,turn the control to full heat,flow stops pump still going,

Is there a part to replace to solve this
Asked 11 years ago by Anonymous

 Sounds like you havea blockage in the hot supply you may have an air lock.

 

 Remove the showerhead and lay  the hose in the bottom ofthe shower tray or bath then with the power turned off turn the shower on tofully hot  and allow to run for about5mins this may draw any air in the system through.

If you have the thermostatic model then check that the inletfilters on the thermostat are clean and clear

 

 

Answered 11 years ago by The Shower Doctor

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the NewTeam 201 Thermostatic / Manual - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our NewTeam Power Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement NewTeam Power Showers

For any other support request please get in touch.