This question is regarding NewTeam Victoriana Thermostatic Valve - Shower Spares

cold water flow

I have taken the shower apart although, I was able to fully dismantle it (see pic). I found the allen key bolt underneath, but I couldn't get the handle off. I replaced some of the rubber O rings, using the service kit.



However I have put the shower back together and now the cold water flow is practically non-exsistant, why would this be?



thanks
Asked 11 years ago by Richard
Since you have not been able to dismantle the shower, you would need to remove the circlip that holds the handle on and remove the handle etc to do this, I think that you have either not turned on the cold water inlet valve or you have not set the shower up right after reattaching it.

Answered 11 years ago by Anonymous

Hi thanks for replying,

Where is the circlip situated, please?

Is it the one that can be seen at the front of the cartrdge shown above? Or is it somewhere else?



thanks





Answered 11 years ago by Anonymous

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the NewTeam Victoriana Thermostatic Valve - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our NewTeam Exposed Shower Valves Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement NewTeam Exposed Shower Valves

For any other support request please get in touch.