solenoid plain shank
Disconnect the wiring from solenoid coil and compression nut on solenoid side from mains inlet, (long arm), you will need a replacement olive and nut for the refit.
Undo screw holding bracket over solenoid valve and remove bracket.
Remove solenoid valve.
Keep and reuse "O" ring that should be on the short arm of the valve.
Fit new solenoid valve with nut then olive on long arm and "O" ring on short arm.
Fit back into shower and replace bracket and screw.
Connect up compression nut to mains inlet. Refit wires to coil.
Turn on water slowly and check for leaks.
Refit cover.
Turn on power....if no bangs etc. test shower.
Well done.
Answered 11 years ago by Anonymous
View Product and Order Online:
Do you need any additional help to find the correct spare part?
Please click the following link if you would like to see other answers or ask a question regarding the Redring Solenoid (plain shank) 93593588
If you've landed here and this question is not about your specific product, please take a look at these similar items on our Redring Other Spares Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.
If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Redring Other Spares
For any other support request please get in touch.