This question is regarding Salamander CT50xtra Shower Pump Spares

Failure to pump

During shower the pump simply stopped pumping. I have checked the fuse which is ok. The trip,in the consumer unit had not tripped. The water pressure is ok. Any suggestions would be helpful please.
Asked 4 years ago by Malcolm Kirby, Leighton buzzard, l
Unusual for a pump just to stop mid shower.

If it has stopped dead then it sounds like an electrical fault, if it is electrical and there is power going to the pump then it is most likely to be a faulty PCB.

However I would swap the flow switch sensors over hot to cold and cold to hot just in case one of these has failed.

But to be honest from your description of the fault it is most likely to be the PCB

Answered 4 years ago by George Thomson

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Salamander CT50xtra Shower Pump Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Salamander Shower Pumps Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Salamander Shower Pumps

For any other support request please get in touch.