Pump not working

You will need to check to see if you have 230-240v into the pump, that the inlet filters are not blocked and that the shower is not the problem.

I am often asked “Is this a DIY job” to be honest I can’t answer that, because without knowing someone, it isn’t possible to assess their skills?

I should say that most jobs on showers although relatively easy (from my point of view) can be fiddly and an extra pair of hands, long thin fingers and the strength in your hands of an all in wrestler are a help!

The secret is, observing very carefully when things are taken to bits, their order and orientation, taking notes and/or photos as you go can also be a help.

When you are working with electricity and water so make sure it is switched off and turned off before you start.

If you think you can do the job but aren’t just that confident, it may help to buy the part and compare it to the faulty part, you will then be able to see where the screws, wires, nuts, or washers etc. go, if then you think it is to complicated, at least you will have the part when the plumber or electrician arrives.

We will always be here to offer help and advice if you run into a problem, however it is not the same as being on site where we can get the overall picture, if you are still not sure, now is the time to call in a professional.