This question is regarding Sirrus Seals Kit - SK1600-1 (Components Identified as A)

Sirrus 1600 - Little water flow

I replaced the seals on a Sirrus 1600 valve as it became difficult to turn on but now have very little water flowing from the shower and appears to be only hot water. Have I re-assembled the cartridge wrongly or is there a way of adjusting the flow? The flow was fine before replacing the seals.
Asked 7 years ago by Steven
If the flow was OK before then there shouldn't be a problem.

There is no way of adjusting the flow so I suspect that something may have gone wrong when reassembling.

Ine of the common faults is the installation of the thermostat when fitting the stat the brass body goes into the shower and the steel pin should be facing out.

Answered 7 years ago by George Thomson

View Product and Order Online:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Sirrus Seals Kit - SK1600-1 (Components Identified as A)

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Sirrus by Gummers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Sirrus by Gummers

For any other support request please get in touch.