This question is regarding Monsoon Pump - Standard 3.0 bar Twin

S3.0-Twin 46416

Our pump runs on after the Tap is closed. I need to switch off the power and switch on again to stop the motor running. What part do I need to solve this problem.
Asked 3 years ago by Ronald Crosby, N Ireland
It is likely that one of the flow switch sensors is faulty or one of the actuators is sticking

www.showerdoc.com/stuart-turner-compatible-single-magnetic-reed-switch-afp7


www.showerdoc.com/stuart-turner-monsoon-n1-5-n3-0-bar-twin-pump-spares

If you look at part 7 in the above image, it is a little torpedo that is inside the outlet candle this rises when the water is turned on, the sensor recognises this and switches the pump on, this may be sticking in the up position.

You can remove / reverse the sensors to check test which end of the pump is causing the fault.

Answered 3 years ago by George Thomson

View Product and Order Online:

Do you need any more information about this pump product?

Please click the following link if you would like to see other answers or ask a question regarding the Monsoon Pump - Standard 3.0 bar Twin

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Stuart Turner Pumps page. Alternatively, if you're looking for any other brands you should view our full range of Pumps.

If you would like to buy this item or look at something similar, please consider one of our Replacement Stuart Turner Shower Pumps

For any other support request please get in touch.