No hot water - Opal

Hello.

I have no hot water from my shower anymore.



I cannot get either the full or half heat options to come on when I click them,

When I do try to push them the low pressure light comes on and no heat comes out. when I let go the shower just returns to the cold setting.



I have tested the TCO and thereI am getting a signal so I don't think this is the problem.



What else can I test? What do you think the problem might be?



Thank You



Asked 12 years ago by Anonymous
Check that incoming water mains stopcock and any isolation valve in the feed to the shower are fully open.
Check with your supplier if there has been any reduction in water supply flow or pressure.
Check that gauze filter in inlet to solenoid valve is clear.
If all above are ok then with shower on check that actuator on top of the flow valve is operating the small button switch on the bottom of the printed circuit board , if it is not then it is the flow valve at fault.
If the switch is being activated then it is the power printed circuit board that requires to be replaced.
Either part can be ordered online via the kink below.

http://www.showerdoc.com/shower-spares/triton/TRITO-PARENT-89-Triton-Opal-II

Answered 12 years ago by Anonymous

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Triton Opal II - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Triton Electric Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Triton Electric Showers

For any other support request please get in touch.