This question is regarding Triton Opal - Shower Spares

Too Hot

I have a opal 10.5 KW shower, it has been fine for 2/3 years but just recently we have had to keep it on number 1 on the hot setting, and it is almost too hot to bare, water pressure is good, putting it on the lower heat setting and turned up to 10 it is barely warm and you only get a very low pressure, we have replaced the shower head and hose. Any suggestions please.
Asked 13 years ago by Roger
This is a water flow problem ie too low.
Check that the mains stopcock and any isolation valve in the feed to the shower are fully open.
Check the inlet filter on the solenoid valve in to the shower is clear.
If all of above ok then it is likely to be the stabiliser valve that requires replacing, it can be ordered online by clicking on the link below.

http://www.showerdoc.com/shower-spares/triton/TRITO-82600810-Stabiliser-valve-assembly-10-5kW

Answered 13 years ago by Anonymous

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Triton Opal - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Triton Electric Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Triton Electric Showers

For any other support request please get in touch.