This question is regarding Triton Rapide 4 - Shower Spares

low pressure switch comes on

when i turn the shower on the cold setting works, as soon as i press for hot water the low pressure light comes on , The water still comes through but cold , water pressure is ok, suspect pcb as low pressure switch is pressed in, so either its the switch or something else on the pcb
Asked 12 years ago by Anonymous
Check that incoming mainsater stopcock and any isolation valve in feed to shower are fully open
Check with your supplier if there has been any reduction in watwer flow or pressure.
Check that gauze filter in inlet to solenid valve is clean
If all above ok then with shower switched on check that actuator on top of the stabiliser valve is operating the small switch on the bottom of the printed circuit board. If it is then it is the pcb at fault and if not then it is the stabiliser valve that is faulty.
Either part can be ordered online by clicking on the link below

http://www.showerdoc.com/shower-spares/triton/TRITO-PARENT-96-Triton-Rapide-4

Answered 12 years ago by Anonymous

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Triton Rapide 4 - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Triton Electric Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Triton Electric Showers

For any other support request please get in touch.