This question is regarding Triton T300si Remote - Shower Spares

T 300 SI

Shower low pressure light flashing and water runs cold. Water pressure is fine. Turn up temperature and low pressure light light goes out and water heats up. Turn temperature down and low pressure flashing and cold again.
Asked 3 years ago by Ian Elcock (Electircian, Wiltshire
I think you may have a faulty stab valve or stepper motor however carry out the checks below first

First check that the valve coming into your house and the valve on the line to your shower are both fully open if they are OK then it is likely to be a faulty stabiliser / flow valve.

The reason for this is there may not enough water passing through the shower to activate the safety device there fore it will not allow power through to the elements

Answered 3 years ago by George Thomson

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Triton T300si Remote - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Triton Electric Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Triton Electric Showers

For any other support request please get in touch.