This question is regarding Triton T300si Remote - Shower Spares

Triton T300 Si Remote - Faulty TCO

Recently my shower started running cold. The TCO was showing no continuity and so I replaced it. The shower worked great. A couple of days later I had the same fault and so replaced the TCO again. It ran great for a couple of showers and then went again. There is obviously a reason why this keeps happening but do you have any ideas why?



Thanks for your help.
Asked 10 years ago by David

After fitting a new TCO

When fitting a new TCO listen to the shower, after it has completed its first on/off cycle, if when it is switched off you hear it continuing to heat (Noise like a kettle starting to boil) this will mean that there is a switch or a relay that is stuck in the on position, this is keeping an element energised and this is probably what caused the original TCO to fail.

If this is the case replace the faulty switch or relay and make sure that you switch the shower off at the isolating switch when the shower is not in use because this may cause the new TCO to fail.

Answered 10 years ago by Anonymous

View Spares and Order Parts:

Do you need any additional help to find the correct spare part?

Please click the following link if you would like to see other answers or ask a question regarding the Triton T300si Remote - Shower Spares

If you've landed here and this question is not about your specific product, please take a look at these similar items on our Triton Electric Showers Spares page. Alternatively, if you're looking for any other brands you should view our full range of Shower Spares.

If you do not want to proceed with a repair or you want to buy this item or similar, please consider one of our Replacement Triton Electric Showers

For any other support request please get in touch.