Bath mixer filler valve
Answered 6 years ago by Barrie Seabright
1 That the main valve coming into your house is fully open.
2 Then check that the valve on the line to the shower is fully open.
If these valves are not fully open then there may not be enough water getting to your shower to cool it properly, it overheats the safety device cuts in (TCO) and turns the power off to the elements until it cools down and it all starts again!
Make sure that the inlet filter , the shower head is clean and clear, that the hose isn’t kinked (this can happen just behind the hand set where it is difficult to see) also check the inside of the hose although it can look OK on the outside it could have collapsed internally
The other possibility is a faulty flow/stabilizer valve not allowing the correct amount of water into the shower.
There is a link below that explains the above.
www.youtube.com/watch?v=m0xrObqfGqg
Answered 6 years ago by Barrie Seabright
View Product and Order Online:
Do you require any further help with Tap or Shower Cartridges?
Please click the following link if you would like to see other answers or ask a question regarding the Vola Thermostatic Cartridge - VR3277K
If you've landed here and this question is not about your specific product, please take a look at these similar items on our Vola Cartridges page. Alternatively, if you're looking for any other brands you should view our full range of Cartridges.
If you would like to buy this cartridge or look others from the same brand, please view our Replacement Vola Cartridges (All)
For any other support request please get in touch.